A formatting of a disk involves two quite different processes that have come to be known as "low-level formatting" and "high-level formatting." Low-level formatting deals with formatting of disk surfaces required by the disk controller hardware. High-level formatting deals with software-specific information written by a specific operating system.
The process is most easily seen with a standard 1.44MB PC floppy disk. Low-level formatting of the floppy normally writes 18 sectors of 512 bytes each on each of 80 tracks (40 on each side) of a floppy disk. That provides 1,474,560 bytes of storage on the floppy. (Sectors are actually larger than 512 bytes as they include sector numbers, CRC bytes, and other information required in order to identify and verify the sector during reading and writing.) Low-level formatting installs characteristics like sector numbers that are visible to, and used by, the hardware and disk controller. To further complicate the concept, different low-level formats can be used on the same media; for example, large records can be used to cut down on interrecord gap size. Linux supports a variety of sector sizes, and MS-DOS and Windows support a large-record-size DMF formatted floppy format.
On the other hand, high-level formatting is unique to a file system. In the case of MS-DOS (FAT12), the writing of an initial "boot" record—which may just contain code to indicate the disk is not bootable—is required, as well as two copies of the file allocation table and an empty root directory.
In the case of floppy disks, both high- and low-level formatting are customarily done in one pass by user software—FORMAT in the case of MS-DOS. In recent years, most floppies have shipped preformatted from the factory as MS-DOS FAT12 floppies. It is possible—if not always easy—to reformat them to other formats.
Early hard drives were quite similar to floppies, but the low-level formatting was generally done by the BIOS, rather than by the operating system. This was a fairly bizarre process that involved using the MS-DOS debug program to transfer control to a routine hidden at different addresses in different BIOSs.
Starting in the early 1990s, the low-level formatting of hard drives became more complex as technology improved to
Today, an end-user, in most cases, should never perform a low-level formatting of an IDE or ATA hard drive; reinitializing an IDE or ATA hard drive is much more common. (The NOSPIN Group, Inc., n.d.).
Formatting a floppy disk
Low-level formatting
High-level formatting
Low-level formatting a hard disk drive
Rather than face ever-escalating difficulties with BIOS versioning, disk vendors started doing low-level formatting at the factory. High level formatting is done on a per-partition basis, and it formats the partition to work with a specific file format.References